![]() ![]() ![]() ![]() The chip spec sheet calls for the 5V logic supply to be applied and settled before the motor drive voltage is applied. Users of this family of Chinese boards should be aware that many, if not all, apply power to the TB6560 in completely the wrong order. A reverse engineered schematic of the 3 axis variant of these boards is available at NOTE: This board is closed source, which means we'll have oodles of trouble printing it. NOTE: During tests I managed to kill 3 different TB6560 drivers (one by just hooking scope to the output) NOTE: When I contacted ebay seller about the faulty driver board (they delayed sending me replacement) he told he they had received 3 faulty boards at once and were asking which one is mine NOTE: This stepper driver board is HIGHLY experimental within the reprap community ( less than 3 known users, none 100% satisfied with their configuration yet) The board is reprapable or not?! Are sanguino, arduino, pololu driver or any other ?! Maybe this is for "discussion page" and not for here. No one's going to stuff it into the "Official" Electronics any time soon. Note: this board is neither reprappable nor open source, so it's a bit questionable whether it belongs into this Wiki.īogdan stuffed it into the wiki since he's using one or two,Īnd he suggests folk may want to check them out. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |